Ingredients:-
Idea-ology Trinkets
Please note that Grungepaper and Glossy Accents are currently out of stock.
1. Mist the chipboard flower with water and then put through your Big Shot/ Cuttlebug in an embossing folder.
2. Dry with Heat gun and then paint with Juniper Acrylic ... dry again with Heat gun.
3. Sand the high points with a sanding block. I roughed up some of the edges too for a really shabby look.
4. Blend Frayed Burlap Distress Ink over the top. Spritz generously with a gold or green glimmer mist.
5. Make a rose from Grungepaper using the same colours etc., There is a tutorial for a rose on my blog here.
6. Attach the rose to the centre of the flower and add a leaf. Add a few dew drops and you are finished. This will make a great topper for any project.
7. I added a few Idea-ology bits to mine and a pin at the back ... Ta Da ... a piece of wearable chip!
